Doors

Door Panel/Plastic Cover Replacement

1. If applicable, remove the regulator handle by pulling the clip out a wire hook.

NOTE: Install the regulator handle so it points forward and up at a 45 degree angle with the glass closed.

2. Remove the screw, then pull the inner handle forward and out half-way, and disconnect the inner handle rod.

NOTE: Take care not to bend the inner handle rod.

3. Remove the mirror cover panel (see page 20-28).

4. Remove the screw, then release the clips that hold the door panel.   .

NOTE: Remove the door panel with as little bending as possible to avoid creasing or breaking it.