WARNING
1. Loosen the front wheel nuts slightly, then raise the car and support on safety stands.
2. Remove the caliper bolt, and pivot the caliper up oui of the way.
NOTE: Check the hoses and pin boots for damage or deterioration.
3. Remove the pad shims, pad retainers and pads.
4. Using vernier calipers, measure the thickness of each brake pad lining.
Brake Pad Thickness:
Standard: 11.0-11.7 mm (0.44-0.46 in) Service Limit: 1.6 mm (0.06 in)
NOTE: Measurement does not include pad backing plate thickness.
5. If the brake pad thickness is less than service limit, replace the front pads as a set.
6. Clean the caliper thoroughly; remove any rust, and check for grooves or cracks.
7. Check the brake disc for damage or cracks. 8. Install the pad retainers.