ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ! Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!

Rear Brake Caliper

Reassembly

WARNING

Never use an air hose or dry brush to clean brake assemblies.

Use a vacuum cleaner to avoid breathing brake dust.

Contaminated brake discs or pads reduce stopping ability.

When reusing the pads, install them in their original positions to prevent loss of braking efficiency.

CAUTION:

Do not spill brake fluid on the car; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

Clean all parts in brake fluid and air dry; blow out all passage with compressed air.

Before reassembling, check that all parts are free of dust and other foreign particles.

Replace parts with new ones whenever specified to do so.

Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.

Do not mix different brands of brake fluid as they may not be compatible.

Do not reuse the drained .luid. Use only clean DOT 3 or 4 brake fluid.

NOTE:

Coat piston and caliper bore with clean brake fluid.

Replace all rubber parts with new ones whenever disassembled.

Brake cylinder grease (P/N: 08733-B020E) or equivalent rubber grease.

Silicon grease (SHIN ETSU G40M) or equivalent silicon grease.