Starting System

Clutch Interlock Switch Test

1. Remove the dashboard lower cover and knee bolster, then disconnect the 2-P connector from the switch.

2. Check for continuity between the terminals according to the table.

3. If necessary, replace the switch or adjust the switch position (see Section 12).

Starter Solenoid Test (Nippondenso)

1. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). Coil is OK if there is continuity.

2. Check the pull-in coil for continuity between the S and M terminals.
Coil is OK if there is continuity.