Steering Lock Replacement

CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
•   Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
•   Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

1. Disconnect the negative cable from the battery.

2. Remove the dashboard lower cover and knee bolster (see page 23-70).

3. Disconnect the 5-P and 7-P connectors from the under-dash fuse box.
4. Remove the steering column covers.

5. Remove the column holder mounting bolts and nuts.

6. Lower the steering column assembly.