Ignition Switch

Test

CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
•   Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
•   Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

1. Remove the dashboard lower cover and knee bolster (see page 23-70).

2. Disconnect the 5-P and 7-P connectors from the under-dash fuse box.

3. Check for continuity between the terminals in each switch position according to the table.

4. If continuity checks do not agree with the table, replace the steering lock assembly.

View from wire side