Under-Dash Fuse Box

Removal/Installation

CAUTION:
•   Be sure to install the SRS wiring so it is not pinched or interfering with other car parts.
•   Before disconnecting any part of the SRS main harness, install the short connector (RED) on the airbag.

Removal:
1. Disconnect both the negative cable and positive cable from the battery.

2. Remove the access panel from the steering wheel, then remove the short connector.
5. Remove the dashboard lower cover and knee bolster.

3. Disconnect the connector between the airbag and cable reel.
4. Connect the short connector to the airbag side of the connector.