SRS Unit Removal

CAUTION:
• Before disconnecting any part of the SRS wire harness, install the short connector on the airbag.
• Do not damage the SRS unit terminals or connectors.
•   Do not disassemble the SRS unit; it has no serviceable parts.
•   Store the SRS unit in a clean, dry area.
•   Do not use any SRS unit which has been subjected to water damage or shows signs of being dropped or improperly handled, such as dents, cracks or deformation.
1. Disconnect the battery negative cable, then the positive cable.
2. Install the short connector on the airbag (see page 23-274).
3. Remove the right side cover from the SRS unit.

4. Remove the left side cover from the SRS unit, then disconnect the SRS main harness 18-P connector from the SRS unit.

5. Remove the 4 SRS unit TORXe bolts, then pull the SRS unit out from the driver's side.