ВНИМАНИЕ! График работы на майских праздниках: Офис в Москве: 9 мая ВЫХОДНОЙ!
Офис в СПБ: 1 мая, 9 мая - ВЫХОДНОЙ!
Cable Reel Installation
CAUTION:
• Before installing the steering wheel, the front wheels should be aligned straight ahead.
• Be sure to install the harness wires so that they are not pinched or interfering with other car parts.
• After reassembly, confirm that the wheels are still turned straight ahead and that the steering wheel spoke angle is correct. If minor spoke angle adjustment is necessary, do so only by adjustment of the tie-rods, not by removing and repositioning the steering wheel.
1. Align the cancel sleeve grooves with the cable reel projections.
2. Carefully install the cable reel and the cancel sleeve on the steering column shaft. Then attach the connector holder to the steering column.
3. Install the steering column upper and lower covers.
4. Center the cable reel.
Do this by first rotating the cable reel clockwise until it stops. Then rotate it counterclockwise (approximately two turns) until:
• The yellow gear tooth lines up with the mark on the cover.
• The arrow on the cable reel label points straight up.
5. Install the steering wheel and attach the cable reel connector to the clip.
6. Connect the horn connector and cruise control connector.