Set/Resume Switch Test

With SRS:

CAUTION: Disconnect the negative and positive battery cables. Install the short connector on the airbag (see page 23-273).

1 . Remove the dashboard lower cover.
2. Disconnect the 3-P connector from the cable reel harness and the airbag assembly.
3. Remove the steering column lower cover.
4. Disconnect the cable reel harness 6-P connector from the SRS main harness, then connect the Test Harness C to the cable reel half of the connector.

5. Check for continuity between the 8-P test harness connector and the terminals in each switch position according to the table.
•   If there is no continuity, go to step No. 6.

6. Pry the cover off the set/resume switch and remove the switch by removing its two screws.

7. Check for continuity between the 8-P test harness connector and the cable reel connector (switch side) according to the table.

•   If there is continuity between all the terminal pairs, replace the switch.
• If there is no continuity between any one of the terminal pairs, replace the cable reel (see page 23-293).