Rear Wiper Motor Replacement

1 . Remove the trim cover, nut, and rear wiper arm, then remove the outside rubber seal, special nut, and washer.
2. Open the rear hatch and remove the wiper motor cover.
3. Disconnect the 4-P connector from the wiper motor.
4. While holding the wiper motor with one hand, remove its 3 mounting nuts with the other.

Washer Motor Test

1. Remove the front bumper.

2. Disconnect the 2-P connector from the washer motor.
3. Test either washer motor operation by connecting battery power to the O+ terminal and grounding the e terminal.
•   If the motor fails to run smoothly, replace it.
•   If the motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged pump outlet in the motor.