Wipers/Washers

Rear Wiper Motor Test

1. Open the rear hatch and remove the wiper motor cover.

2. Disconnect the 4-P connector from the wiper motor assembly.

3. Test motor operation by connecting battery power to the No. 2 (GRN/BLK) terminal and ground to the No. 4 (GRN) terminal.

4. If the motor fails to run smoothly, replace it.
5. Reconnect the 4-P connector to the rear wiper motor assembly.

6. Connect an analog voltmeter between the No. 3 (LT GRN/BLK) and the No. 1 (BLK) terminals. Run the motor by turning the wiper switch ON.

Voltmeter should indicate 0 V to more than 4 V alternately.