Moonroof

Function Test

NOTE: Be careful not to damage the switch and the dashboard panel.

1. Carefully pry the switches out from the dashboard.
2. Disconnect the connectors from the switches.

3. Connect the YEL terminal to body ground with a jumper wire.
The moonroof should open when the ignition switch is turned ON.
•   If the moonroof opens, check the switch.

•   If not, check for an open in the YEL wire.
4. Connect the YEL/RED terminal to body ground with a jumper wire.
The moonroof should close when the ignition switch is turned ON.
•   If the moonroof closes, check the switch.

•   If not, check for an open in the YEL/RED wire.
5. Connect the BLU terminal to body ground with a jumper wire.
The moonroof should tilt up when the ignition switch is turned ON.

•   If the moonroof tilts up, check the switch.

•   If not, check for an open in the BLU wire.
6. Check for continuity to body ground on the BLK wire.

•   There should be continuity to ground.
•   If there is no continuity, check for an open in the BLK wire.