Door Mirror Replacement

1. Carefully pry out the cover panel with a flat tip screwdriver, then disconnect the 8-P connector from the door mirror actuator.

2. Test actuator operation:
TILT UP:   Connect battery power to the No. 1 terminal and ground to the No. 2 terminal.
TILT DOWN: Connect battery power to the No. 2 terminal and ground to the No. 1 terminal.
SWING LEFT: Connect battery power to the No. 2 terminal and ground to the No. 3 terminal.
SWING RIGHT: Connect battery power to the No. 3 terminal and ground to the No. 2 terminal.

3. If the mirror fails to operate properly, replace it.

Door Mirror Test

1. Carefully pry out the cover panel with a flat tip screwdriver.

2. Disconnect the 8-P connector from the mirror.

3. While holding the mirror with one hand, remove its mount nuts with the other.