Clock

Replacement

CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
•   Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
•   Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.
•   After installation of the gauge assembly, recheck the operation of the SRS indicator light.


1. Carefully pry the hazard switch out of the instrument panel.

2. Remove the 3 screws, then remove the instrument panel from the dashboard.

3. Disconnect the 4-P connector from the instrument panel.