Trunk/Cargo Area Light

Test/Replacement

1. Pry the trunk/cargo area light lens out of its housing.
2. Pry out the light assembly.

3. Disconnect the 2-P connector from the housing.

4. Make sure that the bulb is in good condition. Check for continuity between A(+) and B(-) terminals.

Latch Switch Test/Replacement

1 . Open the hatch or trunk lid, then remove the trim panel (see Section 20).
2. Disconnect the connector from the latch switch.

3. There should be continuity between the positive terminal and body ground when the latch is in open position, no continuity when it's in the closed position.