Lighting System

Daytime Running Lights Control Unit Input Test (Canada)

CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
•   Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
•   Replace the entire affected SRS harness assembly if
it has an open circuit or damaged wiring.
1. Remove the dashboard lower cover and knee bolster.
2. Disconnect the connectors from the daytime running lights control unit.
3. Make the following input tests at the connector terminals.
If all tests prove OK, yet the system still fails to work, replace the control unit.