Shift Position Console Switch Replacement

1. Remove the console, then disconnect the 14-P connector from the console switch.

2. Remove the 2 console switch mounting nuts.

3. Position the switch slider to "Neutral" as shown above.
4. Shift the select lever to "Neutral", then slip the console switch into position.
5. Attach the switch with the 2 nuts.

6. Test the console switch in the P and N positions of the shift lever.
NOTE: The engine should start when the shift lever is in position N anywhere in the range of free play.

7. Connect the 14-P connector, clamp the harness and install the console.

Shift Position Console Switch Adjustment

1. Shift to the "P" position, and loosen the nuts.

2. Slide the switch in the direction of D position [within 2.0 mm (0.079 in.)] so that there is continuity between No. 7 and No. 10 terminals in the range of free play of the shift lever.
3. Recheck for continuity between each of the terminals.
NOTE:
•   If adjustment is not possible, check for damage to the shift lever detent and/or the bracket.
If there is no damage, replace the console switch.
•   The engine should start when the shift lever is in position N in the range of free play.