Shift Lever Position Indicator

Indicator Input Test

CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
•   Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
•   Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

Remove the gauge assembly from the dashboard (see page 23-130), and disconnect the 14-P connector from it. Make the following input tests at the connector terminals. If all tests prove OK, yet the indicator still fails to work, replace the gauge assembly.

NOTE:
• Several different wires have the same color. They have been given a number suffix to distinguish them (for example GRN' and GRN2 are not the same).
•   Do not disconnect any connectors on the underdash fuse box except the integrated control unit.