Seat Belts

Inspection

Retractor Inspection
1. With the retractor installed, check that the belt can be pulled out freely.

2. Make sure that the belt does not lock when the retractor is leaned slowly up to 15° from the mounted position. The belt should lock when the retractor is leaned over 400.

CAUTION: Do not attempt to disassemble the retractor.


3. Replace the belt assembly with anew one if there is any abnormality.
On-the-Car Belt Inspection
1. Check that the belt is not twisted or caught on anything.
2. After installing the anchors, check for free movement on its retaining bolt. If necessary, remove the bolt and check that the washers and other parts are not damaged or improperly installed.

3. Check the belts for damage or discoloration. Clean with a shop towel if necessary.

CAUTION: Use only soap and water to clean.

NOTE: Dirt build-up in the metal loops of the seat belt anchors can cause the belts to retract slowly. Wipe the inside of the loops with a clean cloth dampened in isopropyl alcohol.

4. Check that the belt does not lock when pulled out slowly. The belt is designed to lock only during a sudden stop or impact.
5. Make sure that the belt will retract automatically when released.

6. Replace the belt assembly with a new one if there is any abnormality.