Moonroof

Wind Deflector Adjustment

NOTE: A gap between deflector seal and roof panel will cause wind noise when driving at high speed with the moonroof open.
1. Open the moonroof and pry the rail covers off both sides.

2. Loosen the deflector mounting nuts.

NOTE: The wind deflector can be adjusted 2 mm (0.08 in) forward or backward.

3. Adjust the deflector forward or backward so the edge of its seal touches the roof panel evenly. The deflector seal should touch the roof panel across entire front edge.
NOTE: The height of the deflector arm when open cannot be adjusted. If damaged or deformed, replace it (page 20-51).

Sliding Glass Replacement

1. Close the glass fully.

2. Slide sunshade all the way back.

3. Pry the plug out of each bracket cover, remove the screw, and slide the cover off to the rear.

4. Remove the mounting nuts from the glass brackets on both sides.

5. Remove the glass by lifting up and pulling forward as shown.

NOTE: Do not damage the roof panel.

6. Install the glass in the reverse order of the removal procedure.

7. Check for water and air leaks.

NOTE: Do not use high pressure water.