Ball Joint Boot Replacement

1. Remove the circlip and the boot.

CAUTION: Do not contaminate the boot installation section with grease.
2. Pack the interior of the boot and lip with grease.

3. Wipe the grease off the sliding surface of the ball pin, then pack the lower area with fresh grease..
CAUTION:
•   Keep grease off the boot installation section and the tapered section of the ball pin.
•   Do not allow dust, dirt, or other foreign materials to enter the boot.

4. Install the boot in the groove of the boot installation section securely, then bleed air.

CAUTION: After installing the boot, check the ball pin tapered section for grease contamination and wipe it if necessary.